Independent research. Reader-supported. Affiliate Disclosure
HUONGMMO PICKS

Finnmark FD-2 Infrared Sauna: Size, Power and Setup Checklist

Check the fit before you order: the space, the delivery path from the curb, and the electrical circuit.

Affiliate Disclosure: We may earn a commission if you purchase through links on this page, at no additional cost to you.

Specifications and policies last checked: September 25, 2026

If you’re considering a two-person infrared sauna, the practical questions usually come before style: Will it fit? Can it get from the curb into your home? Can your electrical setup support it? This guide walks through those three checks for the Finnmark FD-2, using the published specifications and store policies.

What We Haven’t Done

HUONGMMO PICKS has not personally tested the Finnmark FD-2. This guide is based on Topture’s FD-2 product page, Topture’s shipping and refund policies, and Finnmark’s FD-2 installation manual. We don’t make health claims about sauna use.

Key Specifications

SpecListed value
Type2-person full-spectrum infrared sauna, marketed for indoor useSource: Topture FD-2 page
Exterior48″ W × 43.5″ D × 78.3″ HSource: Topture FD-2 page
Interior44.3″ W × 39.8″ D × 70.5″ HSource: Topture FD-2 page
Sauna door23.63″ W × 67.88″ HSource: Topture FD-2 page
ClearanceAt least 3″ above the cabin and on each sideSource: Topture FD-2 page · FD-2 manual
ElectricalDedicated 120V / 15A circuit with a NEMA 5-15 outlet; 1,750W, single phaseSource: Topture FD-2 page
Shipping package78″ × 36″ × 50″, 441 lb (the package, not the largest panel inside)Source: Topture FD-2 page

Before ordering, confirm these figures for the unit being supplied, and follow the manual that comes with it.

1 · Will it fit the room?

Start with the exterior size, then add the clearance and room to open the cabin door. Topture’s FD-2 page and the FD-2 manual list at least 3″ of clearance above the cabin and on each side.

Room planning sketchTop-down sketch of a room. The sauna footprint sits away from the walls, with a shaded clearance zone visible on all four sides, the cabin door swing in front, an outlet on the wall, and lettered measurements A to E.Room doorFD-2footprint≥ 3″ oneach sideABCDE
A room width · B room depth · C clearance: at least 3″ above the cabin and on each side · D space for the cabin door to open · Eoutlet on the circuit you’ll confirm in step 3. Not to scale. A floor plan can’t show the space above the cabin, so check your ceiling height separately.

Space checklist

  • Floor space for 48″ × 43.5″ plus at least 3″ on each side
  • Ceiling high enough for the 78.3″ cabin plus at least 3″ above it, with extra headroom for installation
  • Space in front of the cabin for its door to open fully
  • A spot on a solid surface in a dry area
  • An outlet at the install spot, on the circuit you’ll confirm in step 3
Sources: Topture FD-2 page · Finnmark FD-2 manual

2 · Can it get from the curb to the room?

Topture lists free standard shipping to the 48 contiguous U.S. states, and standard delivery is curbside, so plan how the package will get from the curb to the install room. If your address is outside the 48 contiguous states, ask Topture about delivery before you order.

Topture lists the shipping package at 78″ × 36″ × 50″ and 441 lb. These figures are for the package, not for the largest panel inside it, and they don’t tell you whether it will fit through your doorways and turns. Compare them with your measurements, and ask Topture before ordering if anything looks tight.

Delivery path from the curbSketch of a delivery route from the curb up a walkway and steps, through the front door, along a hallway with a turn, to the install room. Six numbered points mark where to measure.STREET · CURBCurbside drop-offInstall room ↓123456
Measure at each numbered point. The sketch shows whereto measure; it doesn’t mean the package will fit. Compare each point with the package size above. Not to scale.
  • Walkway or driveway: surface, slope and width for a hand truck and helpers
  • Outside steps: number of steps, and any railings or tight landings
  • Front door: clear width and height with the door fully open
  • Hallway: narrowest width along the route
  • Turns and corners: space to pivot a 78″-long package
  • Room door and any interior stairs: clear width, height and headroom
  • If the package looks too big for any point on the route, ask Topture how the FD-2 can be brought in before you order
Sources: Topture FD-2 page · Topture Shipping Policy

3 · Confirm the electrical circuit

Topture’s FD-2 requirement

A dedicated 120V / 15A circuit with a NEMA 5-15 outlet

Source: Topture FD-2 page(Installation & Electrical)

“Dedicated” refers to the circuit: it serves only the sauna. Whether your home already has such a circuit at the install spot is something a qualified, licensed electrician can confirm.

Before ordering,have a qualified, licensed electrician confirm that your home can meet this requirement, and follow the manual that comes with your unit. This guide doesn’t give wiring instructions.

  • Have a licensed electrician confirm a dedicated 120V / 15A circuit with a NEMA 5-15 outlet at the install spot
  • Read the electrical section of the manual that comes with your unit

Delivery, damage, returns and installation: know this before you order

Short summaries of Topture’s current policies. Read the full policy at each link before you buy, because terms can change.

On arrival

  1. Inspect the packaging before you sign.
  2. If you see damage: write a specific description of it on the delivery paperwork.
  3. If you don’t see damage:Topture’s policy says to sign with the note “SUBJECT TO INSPECTION.”
  4. Within 24 hours of delivery: photograph and report any damage to Topture, whether you see it on arrival or find it after unpacking (concealed damage).
  5. Within 48 hours of delivery: report any missing parts.
  6. Keep all the packaging until any claim or return is settled.

Plan to unpack and inspect within 24 hours of delivery — concealed damage must be reported in that window, even if installation happens later.

Source: Topture Shipping Policy

Returns (general policy)

  • Request a return within 30 days of delivery.
  • Eligible items must be new, unassembled, not connected to power, and in their original packaging.
  • A restocking fee of at least 25% applies, plus applicable shipping costs.
  • This is Topture’s general policy. Before ordering, confirm with Topture which return terms apply to your FD-2 order, including whether it is final sale or made to order.
Source: Topture Refund Policy

Installation

  • Topture’s FD-2 page notes that the manual calls for professional installation.
  • Before ordering, ask Topture who can install the FD-2 in your area and what it costs.
Sources: Topture FD-2 page · Finnmark FD-2 manual

Warranty

  • Cabin: 10 years for indoor residential use.
  • Heaters, LED lighting and controls: Topture’s FD-2 page and the warranty PDF linked from it currently list different coverage periods. Before ordering, confirm with Topture which written warranty applies to your FD-2 order.
Sources: Topture FD-2 page · Warranty PDF (dated Dec 12, 2022) linked on that page

Bottom Line

If the space, the delivery path and the electrical circuit all check out, and you’ve confirmed installation and the return terms for your order, you can see current pricing and availability on Topture.

Affiliate Disclosure: We may earn a commission if you purchase through links on this page, at no additional cost to you.

Sources

Specifications and policies last checked: September 25, 2026